This is the radio controlled, brushless electric powered, Rx-Ready
                  DG-1000 79" Scale Glider from ST Model.
            For thermal glider flyers 12 years of age and older.

FEATURES: Construction: EPO foam, self aligning snap and lock construction
          Wings: Two-piece, high aspect ratio with lightweight wing tubes
            for strength without a lot of weight
          Aileron Control: Dual servo
          Motor: Brushless with RMS (retractable motor system), electronic
            mixer is controllable by throttle speed
          Servos: Four micro and one standard size
          Propeller: 7x5  if replacement prop is needed)
          Canopy: Tinted
          Building Time: Ready to fly in under 1/2 hour

INCLUDES: DG-1000 79" Scale Glider with propeller, motor, ESC, decals
            five servos, electronic mixer and instruction manual

REQUIRES: Transmitter: 6-channel with 6-channel receiver, see COMMENTS
          Motor Battery: 3s 11.1V LiPo
          Deans Male Ultra Connector:  required if using above battery
            (cut existing connector off ESC and solder the Deans Ultra Male
            connector on the ESC
          Charger: LiPo compatible, such as the ElectriFly PolyCharge DC
           Charger (
           

SPECS:    Length: 38.2" (970mm)
          Wingspan: 79.1" (2010mm)
          Flying Weight: 36.5oz (750g)
          Wing Area: 348.7 sq in (22.5 sq dm)
          Wing Loading: 10.9 oz/sq ft (33.3 g/sq dm)
          Center of Gravity (CG): 2.1" (53mm) behind leading edge of wing when
            the RMS is completely folded
          Control Throws:
            Aileron Up/Down: 10°
            Rudder Left/Right: 20°
            Elevator Up/Down: 15°

COMMENTS: Included instructions for the Retractable Motor System (RMS) in the
            DG-1000 are illustrated using a Futaba T6EXAP in.
          Please note that in , the throttle (CH 3) is on the left stick.
            Stated trim positions and EPA settings are specific to this
            transmitter. Since all transmitters from varying manufacturers may
            have different channel assignments, curves, and endpoint settings,
            you will have to adapt the instructions for your specific radio
            system.
          The transmitter pictured on page 3 of the manual is not included and
            must be purchaed separately.